9 Electrical CAM To create E-CAM Data, import the file “Data_S.txt”. Firstly in this file we set the base unit of E-CAM by specifying SlaveMax=1 and MasterMax=1. Second, select motor unit for E-CAM operation by setting up b1/b0 of D1816. Third, specify the magnification of E-CAM Data according to the input parameters below. In addition, you can also select motor unit then real-time modify the SlaveMax/MasterMax value by DTO instruction. When input parameters are ready, we can obtain 2 settings: 1. Pulses of Winding shaft, 2. SlaveMax / MasterMax. The below table explains how to obtain the 2 settings.
DVP-PM Application Manual 9-62 Input parameters Rounds per layer N1 Total rounds of winding N2 Coil spacing (mm) D Winding shaft (Master/Y axis) Mechanism parameter (mm/revolution) There is no actual moving distance of Master because winding shaft is directly driven by signals. The winding principle is that Slave moves certain distance when Master rotates a round, therefore mechanism parameter of Master can be regarded the same as that of Slave.
A = A Master Slave Servo parameter (pulses/revolution) B Master Mechanical parameter (mm/pulses) C = A /B Master Master Master Coil shaft (Slave/X axis) Mechanism parameter (mm/revolution) A Slave Servo parameter (pulses/revolution) B Slave Mechanical parameter (mm/pulses) C = A /B Slave Slave Slave Setting Winding shaft (Master/Y axis) Length of single speed positioning (pulses) =N2 x B Master Coil shaft (Slave/X axis) Master (pulses) Max =2 x N1 x B Master “2” indicates double layer winding Slave (pulses) max =N1 x D/C Slave