Supermicro SC523 Chassis — 5-4 Removing and Installing the Air Shroud

SC523 Chassis Manual Chapter 5: Chassis Setup and Maintenance 5-3 Removing the Chassis Cover 5-4 Removing and Installing the Air Shroud 4 2 Air Shroud 3 Perforated Tabs 2 2 2 Figure 5-2. Removing the Air Shroud 2 Air shrouds concentrate airflow to maximize fan efficiency. The SC523 chassis air shroud does not require screws to set it up. The air shroud must be removed before a motherboard may be installed. Figure 5-1. Removing the Chassis Cover Removing the Chassis Cover Removing the Air Shroud 1. Power down the system and remove the power cord as described in Section 5-2. 1.

Power down the system and remove the power cord as described in Section 5-2 and remove the cover as described in Section 5-3. 2. Remove the four screws holding the chassis cover in place. 2. Carefully lift the air shroud straight up and out of the chassis. 3. Slide the cover toward the rear of the chassis Installing the Air Shroud 4. Lift the cover up and off the chassis. 1. Each air shroud includes perforated tabs that can be removed to accommo- date motherboard components. To ensure maximum cooling, remove only the tabs that are necessary to ensure a proper fit of the air shroud. Warning: Except for short periods of time, do NOT operate the server without the cover in place.

The chassis cover must be in place to allow proper airflow and prevent overheating. 2. Place air shroud in the chassis. The air shroud covers the fans at the rear of the chassis. 5-2 5-3