Supermicro SC523 Chassis — 5-5 Removing and Installing Hard Drives

SC523 Chassis Manual Chapter 5: Chassis Setup and Maintenance 5-5 Removing and Installing Hard Drives 5 Hard Drives Figure 5-4. Removing the Hard Drive Tray from the Chassis Figure 5-3. Locating the Fixed Hard Drives within the Chassis Removing the Hard Drives and Hard Drive Trays from the Chassis 5. Carefully lift the hard drive tray and hard drive from the chassis. 1. Power down the system and remove the power cord as described in Section 5-2 and remove the cover as described in Section 5-3. 2. Disconnect the wiring to the hard drive. 3. Locate the hard drive that needs to be replaced within the chassis. 4.

Remove the mounting screws holding the hard drive tray into the chassis, and set them aside for later use. Warning: Except for short periods of time (while swapping hard drives), do not operate the server with the hard drives empty. The hard drive tray must have a hard drive or dummy drive installed. 5-4 5-5