Supermicro SC523 Chassis — 5-6 Removing and Installing the DVD or CD-ROM

SC523 Chassis Manual Chapter 5: Chassis Setup and Maintenance 5-6 Removing and Installing the DVD or CD-ROM 7 Hard Drive Prior to installing the motherboard, the DVD or CD-ROM must be removed, then reinstalled after the motherboard has been installed in the chassis. Mounting Screws 4 Drive Tray 6 3 Mounting Screws 6 Figure 5-5. Removing the Hard Drive from the Drive Tray 6. Remove the mounting screws holding the hard drive into the hard drive tray and set them aside for later use. Removing the DVD or CD-ROM Drive Figure 5-6. Removing the DVD or CD-ROM 1. Power down the system and remove the power cord as described in Section 5-2 and remove the cover as described in Section 5-3. 7.

Carefully remove the hard drive from the hard drive tray. Installing a Hard Drive into the Hard Drive Tray 2. Locate and remove the screws holding the DVD-ROM in place, setting aside the screws for later use. 1. Install a new hard drive into the hard drive tray with the printed circuit board side facing down so that the mounting holes align with those in the carrier. 3. If necessary, disconnect any cables to the DVD-ROM and comport tray. 2. Using the screws which were set aside earlier, secure the hard drive into the hard drive tray by tightening all four screws. 4. Slide the DVD-ROM and comport tray toward the rear of the chassis. 5. Lift the DVD-ROM and comport tray free from the chassis.

3. Carefully lower the hard drive tray and hard drive into the chassis. Installing the DVD or CD-ROM Drive 4. Secure the hard drive tray to the chassis using the screws set aside earlier. 1. Carefully slide the DVD or CD-ROM and comport tray into the opening in the front of the chassis. 5. Reconnect the wiring to the hard drive. Warning: Only enterprise level hard drives are recommended for use in Supermicro chassis. 2. Secure the drive with the screws previously set aside and reattach the wiring. 5-6 5-7