Supermicro SC523 Chassis — Motherboard Installation

SC523 Chassis Manual Chapter 5: Chassis Setup and Maintenance 5-7 Installing the Motherboard This section describes how to install the motherboard to the chassis. To do this, you are required to remove the air shroud, hard drive, hard drive tray and DVD or CD-ROM drive prior to installing the motherboard. See the previous sections for instructions on how to remove these components. Permanent and Optional Standoffs Standoffs prevent short circuits by securing space between the motherboard and the chassis surface. The SC523 chassis includes permanent standoffs in locations used by most motherboards. Some motherboards require additional screws for certain CPUs, heatsinks, and other components.

Optional standoffs are included for these motherboards. To use an optional standoff, screw the standoff into the chassis in the use the optional standoff in the same manner as the permanent standoffs. I/O Shield M/B standoff 6-32 to 6-32 M/B (CPU) standoff M5 to 6-32 Pan head 6-32 x 5 mm [0.197] Figure 5-8. Motherboard Standoffs and Motherboard Pan Head Screw Figure 5-7. Installing the I/O Shield Motherboard Installation Installing the I/O Shield Once the air shroud, hard disk drive tray, DVD or CD-ROM have been removed and any additional standoffs have been placed, the motherboard may be installed in the chassis. The I/O shield holds the motherboard ports in place.

Install the I/O shield before installing the motherboard. Installing the I/O Shield: Installing the Motherboard 1. Power down the system and remove the power cord as described in Section 5-2 and remove the cover as described in Section 5-3. 1. Power down the system and remove the power cord as described in Section 5-2 and remove the cover as described in Section 5-3. 2. Review the documentation that came with your motherboard. Become familiar with component placement, requirements, precautions, and cable connec- tions. 2. Review the documentation that came with your motherboard. Become familiar with component placement, requirements, and precautions. 3.

Make sure the I/O shield matches the motherboard ports. You may need to punch out the printer port. 3. Disconnect the chassis from the power source and open the chassis cover. 4. As required by your motherboard, install standoffs in any areas that do not have a permanent standoff. 4. With the illustrations facing the outside of the chassis, place the shield into the space provided. 5. Once installed, the motherboard will hold the I/O shield in place. 5. Lay the motherboard on the chassis aligning the permanent and optional standoffs. In addition, make sure the motherboard aligns with the I/O shield. 5-8 5-9