SC523 Chassis Manual Chapter 5: Chassis Setup and Maintenance 5-9 System Fans 5-10 Power Supply Replacement The SC523 chassis includes two system fans for cooling and air circulation. The SC523 chassis has a 410, 500 or 520 Watt power supply. This power supply is auto-switching capable. This enables it to automatically sense and operate at a 100v to 240v input voltage. An amber light will be illuminated on the power supply when the power is off. An illuminated green light indicates that the power supply is operating. System Fans Power Supply Replacement SC523L-520B or SC523L-410B The SC523L-520B and SC523L-410B chassis models include one power supply.
Replacement units can be ordered directly from Supermicro (see contact informa- tion in the Preface). Removing the Power Supply 1. Power down the system and remove the power cord as described in Section 5-2 and remove the cover as described in Section 5-3. Figure 5-12. Placing the System Fans 2. Disconnect the power connectors from the motherboard. 3. Remove the screws from the power supply panel on the back of the chassis as illustrated. Replacing a System Fan 1. Carefully remove the chassis cover while the system is running. The chas- sis cover should only remain off for brief periods of time while performaning system maintenance. 2. Determine which fan not operating properly. 3.
Take note of the direction that the airflow indicator arrow on the top of the fan is pointing. 4. Press the release tabs on each side of the fan and carefully lift it up and out of the chassis. 5. Replace the fan with a new one of the same model, ensuring that the airflow indicator arrow is pointing in the same direction as the fan being replaced. Figure 5-13. Removing the Power Supply Panel 6. Close the cover and secure it to the chassis. 5-14 5-15 3