Supermicro SC523 Chassis — Installing the Chassis into a Rack

SC523 Chassis Manual Chapter 6: Rack Installation Outer Rails 1 B Rail Brackets 1 A Figure 6-3. Rack Brackets Installing the Outer Rails to the Rack 1. Confirm that the inner rails have been separated from the outer rails. 2. Locate the rail brackets in the accessories box. The chassis package includes four rail brackets and two chassis mounts. The rail brackets have long ovals used to adjust the position of the rails when mounting. The chassis mounts (both short) have one square hole. 3. Secure the short brackets to the front of the outer rails with two M4 screws. 4. Secure the long brackets to the outer rails using two M4 screws.

Tighten the screws loosely so the bracket can slide back and forth. Figure 6-4. Inserting the Inner Rails into the Outer Rails Installing the Chassis into a Rack 5. Position the outer rail and brackets in the rack at the desired level. Chassis Installation 6. Secure the front of the rail to the rack using two M5 rack screws. 1. Confirm that the the inner rails (A) are attached to the chassis and that the outer rails (B) are installed on the rack 7. Slide the rear bracket so that it snugly fits into the rack. Secure the rear bracket to the rack using two M5 screws. 2. Align the inner rails with the front of the outer rails.

Slide the inner rails into the outer rails, keeping the pressure even on both sides (you may have to depress the locking tabs when inserting). 8. Tighten the screws that secure the rear bracket to the rail. 9. Repeat these steps with the other chassis rail. Stability hazard. The rack stabilizing mechanism must be in place, or the rack must be bolted to the floor before you slide the unit out for servicing. Failure to stabilize the rack can cause the rack to tip over. 6-6 6-7