SC811 Chassis Manual C-6 Front Connectors and Pin Definitions #1. Backplane Main Power Connectors The 4-pin connector designated JP10, provides power to the backplane. See the table on the right for pin definitions. #2., #3. SAS Ports The SAS ports are used to connect the SAS drive cables. #4. I 2 C Connector The I 2 C Connector, designated JP44, is used to monitor HDD activity and status. See the table on the right for pin definitions. #5. Sideband Header The sideband header is designated JP51. I 2 C is the default mode setting. For SES- 2 to work properly, you must connect an 8-pin sideband cable. See the table to the right for pin definitions.
C-4 Backplane Main Power 4-Pin Connector (JP10) Pin# Definition 1 +12V 2 and 3 Ground 4 +5V SAS Port Pin Definitions Pin # Definition Pin # Definition 1 Ground 2 TXP 3 TXN 4 Ground 5 RXN 6 RXP 7 Ground I2C Connector Pin Definitions (JP44) Pin# Definition 1 Data 2 Ground 3 Clock 4 No Connection Sideband Headers (JP51) Pin # Definition Pin # Definition 2 SGPIO: SDIN; I2C: Backplane Addressing (SB5) 1 Controller ID (SB6) 4 SGPIO: SDOUT; I2C: Reset (SB4) 3 GND (SB2) 6 GND (SB3) 5 SGPIO: SLOAD; I2C: SDA (SB1) 8 Backplane ID (SB7) 7 SGPIO: SCLOCK; 12C: SCL (SB0) 10 No Connec tion 9 No Connec tion