Appendix C: Backplane Specifiications #6. Activity LED Header The activity LED header, designated JP26 is used to indicate the activity status of each SAS drive. The activity LED is located on the front panel. For the activity lead headers to work properly, connect to them using a 10-pin LED cable. This is only used when the activity LED is not supported by the hard drive. NC = No Connection #7. Upgrade Connector The upgrade connector, designated JP46 is used for manufacturer's diagnostic pur poses only. #8. JTAG The JTAG port, designated JP47, is a signed debugging port.
C-5 SAS Activity LED Header Pin Definitions (JP26) Pin # Definition Pin # Definition 1 ACT IN#0 6 NC 2 ACT IN#1 7 NC 3 NC 8 NC 4 NC 9 NC 5 NC 10 Empty