Super Micro Computer, Inc. SC811 — Super Micro SC811 Chassis Manual PDF Download

SC811 Chassis Manual C-7 Front Jumper Locations and Pin Definitions JP40 JP18 JP50 JP33 JP29 JP34 JP42 Figure C-2: Front Jumpers Explanation of Jumpers Connector Pins 3 2 1 To modify the operation of the backplane, jumpers can be used to choose between optional settings. Jumpers create shorts between two pins to change the function of the connector. Pin 1 is identified with a square solder pad on the printed circuit board. Note: On two pin jumpers, "Closed" means the jumper is on and "Open" means Jumper 3 2 1 the jumper is off the pins. Setting *The buzzer sound indicates that a condition requiring immediate attention has occurred. 1.

Hard drive failure The buzzer alarm is triggered by the following conditions: 2. Fan failure 3. System temperature over 45є Celcius. C-6 Jumper Settings Jumper Jumper Settings Note JP18 Open: Default Closed: Reset Normal Buzzer reset* JP29 Open: Default Closed: Reset Normal MG9071 chip reset