Appendix D: Backplane D-7 Front Jumper Locations and Pin Definitions Figure D-2: Front Jumpers Explanation of Jumpers Connector Pins 3 2 1 To modify the operation of the backplane, jumpers can be used to choose between optional settings. Jumpers create shorts be tween two pins to change the function of the connector. Pin 1 is identified with a square solder pad on the printed circuit board. Note: On two pin jumpers, "Closed" means the jumper is on and "Open" means the jumper is off the pins. Jumper 3 2 1 Setting *The buzzer sound indicates that a condition requiring immediate attention has occurred. The buzzer alarm is triggered by the following condition:
System temperature over 50є Celsius. D-5 JP18 JP25 Socket Settings Jumper Setting Note JP18 Open: No reset (Default) Closed: Reset Buzzer reset* JP25 Open: 45º C Pins 1-2: 50º C (Default) Pins 2-3: 55º C Overheat temperature setting