SC846X Chassis Manual To install drives in the rear drive drawer, first remove the drawer from the rear of the chassis. Removing the Rear Drive Drawer 1. Power down the system as described in Section 5-2 and remove the chassis cover. 2. If any drives are already installed, disconnect the existing power and data cables from the serverboard and the power distributor board. Otherwise the cables will prevent the drawer from sliding all the way out. 3. Identify the drive drawer release button. It is on the inside left wall of the chassis under the chassis shelf the holds the serverboard and fans. See the diagram below. 4.
Reach into the chassis in front of the fans, and pull the release button while pushing the drawer toward the rear the chassis. 5. From the rear of the chassis, pull the drawer out. Position of Release Button When Drawer is Closed (inside chassis) Release Button on Inside of Drawer Wall Release Button Figure 4-8. Drive Drawer Release Latch 4-8