Supermicro SC846X — Supermicro SC846X Chassis User's Manual (4U) – Free PDF Download

Chapter 4: Chassis Setup and Maintenance Installing Drives 1. Remove the rear drive drawer. 2. Obtain the appropriate mounting brackets as described in the table on page 4-7. 3. If a bracket or kit is requred, mount the drives into the bracket. For the hot-swap kit, see the instructions in the following procedure. 4. Mount the brackets and/or drives onto the drawer floor using screws through the bottom of the drawer. 5. Route the cables through the drive drawer as described in Figure 4-13. 6. Slide the drawer into the chassis, taking care with the cables. The drawer release button should click into place. 7. Connect the appropriate cables to the serverboard and power distributor board. 8.

Replace the chassis cover and power up. Figure 4-9. Installing Drive Bracket in the Drawer 4-9