Chapter 4: Chassis Setup and Maintenance 1. Connect the power and signal cables to the devices in the drawer. Routing Cables in the Drive Drawer 2. Route the cables through the O-clip at the front of the drawer. 3. Use zip ties to bundle the cables where indicated in the diagram below. 4. Push the drawer back into the chassis, while pulling the cables that lead to the drawer without breaking or disconnecting the cables, until the drawer clicks into the locked position. 5. Connect the power cable to the 4-pin peripheral connector from the power distributor board. 6.
Route the signal cables through the holes under the fan brackets to the upper level and connect them to the serverboard and power distributor. To Motherboard To Power Distributor Board Zip Ties Drive Drawer Figure 4-12. Routing Power and Signal Cables 4-11