Supermicro SC936E16-R1200B — Supermicro SC936E16-R1200B Chassis Manual: 3U Server with Hot-Swappable Drives

Chapter 4: Chassis Setup and Maintenance 4-5 Installing the Motherboard The I/O shield holds the motherboard ports in place. Install the I/O shield before you install the motherboard. I/O Shield Installing the I/O Shield 1. Review the documentation that came with your motherboard. Become familiar with component placement, requirements, and precautions. 2. Power down the system, remove the power cord from the rear of the power supply and remove the chassis cover as described in Section 4-1. 3. With the illustrations facing the outside of the chassis, place the shield into the space provided. 4. Once installed, the motherboard will hold the I/O shield in place.

Permanent and Optional Standoffs Standoffs prevent short circuits by securing space between the motherboard and the chassis surface. The SC936 chassis includes permanent standoffs in locations used by most motherboards. These standoffs accept the rounded Phillips head screws included in the SC936 accessories packaging. Some motherboards require additional screws for heatsinks, general components and/or non-standard security. Optional standoffs are included to these mother­ boards. To use an optional standoff, you must place the hexagonal screw through the bottom the chassis and secure the screw with the hexagon nut (rounded side up). Chassis Standoffs Figure 4-5:

Installing the Motherboard 4-5