Supermicro SC936E16-R1200B — Supermicro SC936E16-R1200B Chassis Manual: 3U Server with Hot-Swappable Drives

SC936 Chassis Manual Installing the Motherboard 1. Review the documentation that came with your motherboard. Become familiar with component placement, requirements, precautions, and cable connec­ tions. 2. Power down the system, remove the power cord from the rear of the power supply and remove the chassis cover as described in Section 4-1. 3. As required by your motherboard, install standoffs in any areas that do not have a permanent standoff. To do this: A. Place a hexagonal standoff screw through the bottom the chassis. B. Secure the screw with the hexagon nut (rounded side up). 4. Lay the motherboard on the chassis aligning the permanent and optional standoffs 5.

Secure the motherboard to the chassis using the rounded, Phillips head screws. Do not exceed 8 pounds of torque when tightening down the mother­ board. 6. Secure the CPU(s), heatsinks, and other components to the motherboard as described in the motherboard documentation. 7. Connect the cables between the motherboard, backplane, chassis, front pan­ el, and power supply, as needed. Also, the fans may be temporarily removed to allow access to the backplane ports. SC936 chassis include PCI slots for add-on cards and expansion cards. It provides seven low-profile add-on card slots. PCI Slot Setup for Expansion Cards Installing Add-on and Expansion Cards 1.

Power down the system, remove the power cord from the rear of the power supply and remove the chassis cover as described in Section 4-1. 2. Remove the screw holding the cover in place for each low profile add-on/ex­ pansion card slot you want to use. Keep this screw for later use. 3. Connect the add-on cards and/or expansion cards to the mother board. 4. Secure each card to the chassis using the card's L bracket and the screw previously removed. 4-6