5.3 Speed Mode For details on speed mode wiring, see “Speed Control Connection Example”. It is selected by control mode selection (Pn000). The speed control mode is divided into internal speed mode (Pn000=3) and analog speed mode (Pn000=1) according to the command source. 5.3.1 Quick Guide Speed Control Quick Guide Connect each part properly Internal speed control (Pn000=3) The upper system gives a binary signall Analog speed control (Pn000=1) Drive panel display is normal Select internal speed (Pn304, Pn305, Pn306) (/SPD-A, /SPD-B, /SPD-D) The upper system gives a fixed voltage V REF - Monitoring Un103, receiving speed follows given changes? No Is the actual speed consistent with the given?
No Yes See "Analog Input Circuit" for details Confirm the wiring (V - REF) Yes gain setting Pn300, Pn302, Pn303 Confirm analog speed command Enable operation No Run response to meet requirements? Is the direction of operation No Yes Gain adjustment, see consistent with the given? "Adjustment" for details. Yes Confirm Pn301 setting direction. 5.3.2 Basic Settings The quick wizard ends Control mode selection (Pn000=3), internal speed mode, internal speed command direction selection based on digital input (/SPD-D) internal speed command selection A (/SPD-A), internal speed command selection B (/SPD- B) configuration to select the speed instruction.
The control mode selection (Pn000 = 1) is the analog speed mode. The speed command is given according to the voltage of V-REF (CN1-5, CN1-6) and the set value of analog speed command gain Pn300. 93 SD700 Series Servo Technical Manual