When forward, B phase leads 90° When reversing, phase A leads 90° 90° 90° A A B B C C Parameter Pn072 can be set to revert the logic of the AB phase signal of the divided output pulse. Time Time The amplitude of the Z-phase pulse varies with the number of encoder frequency-division pulses (Pn070) and is consistent with the amplitude of the A-phase. The smaller the frequency division pulse number (Pn070) is, the wider the Z-phase pulse amplitude is. Frequency division pulse output wiring Refer to the “Linear Drive Output Circuit” for details on the wiring of the frequency division pulse output.
! The voltage of the encoder divider pulse output is differential ± 5V, the C (Z) phase pulse is very small because of the pulse width, so it is difficult to measure the change with a multimeter, and it needs to cooperate with the high-speed input point of the upper computer to capture the pulse, or the number of encoder divider pulses (Pn070) can be set to the minimum (16), and then cooperate with the multimeter voltage file to measure.
Cautions 92 SD700 Series Servo Technical Manual 220Ω-470Ω Using a li nea r receiver SN75ALS175 PBO PBO - PCO PCO - GND GND Please connect the shield wire according to the FG requirements of the Sheild wire equipment PBO PBO - PCO PCO - GND FG Using a li nea r receiver SN75ALS175 GND Please connect the shield wire according to the requirements of the equipment