VEICHI — SD700 User Manual 20230516

Motor speed r/min Factory setting Maximum input voltage +10V Rated Speed Minimum input voltage - 10V - 30 10 6 - - - 1.5 1.5 6 10 30 Voltage-V Setting range 1.5V~30V corresponding to rated speed Input voltage range 0V~± 10V Adjustment of instruction offset When analog speed control is used, even if the command is 0V, the servo motor may rotate at a slight speed. This is because there is a slight deviation in the instructions inside the servo unit. This slight deviation is called “offset”. There are two methods of automatic adjustment and manual adjustment of offset adjustment.

Automatic adjustment is automatic adjusting command offset (Fn100) and manual adjustment is manually adjusting command offset (Fn101). For details, see “Auxiliary Functions”. ! 1. For automatic adjustment, be sure to adjust the command bias amount in the state of servo OFF and the upper computer (PLC, knob, etc.) giving 0v voltage command. 2. When adjusting manually, observe the operation of the motor while adjusting in the state of servo ON. 3. If the factory setting is restored, the offset adjustment value will not be initialized. Cautions 95 SD700 Series Servo Technical Manual Motor speed Offset V-REF V Offset oltage Motor speed After offset adjustment V-REF Voltage