5.4.4 Speed Limit in Torque Control A function to limit the speed of the servo motor to protect the machine. During torque control, the servo motor is controlled to output a given torque command, but the motor speed is not controlled. Therefore, when the input command torque is greater than the load torque, the motor speed will increase significantly. In this case, the speed needs to be limited by this function. 5.5 Hybrid Control Mode Selection The servo unit can combine the two modes from various control modes and switch them. The control mode is selected by Pn000. The following describes the switching method and switching conditions. 1.
Internal speed control switching (Pn000 = 4, 5, 6) a) The digital input signal distribution mode is internally fixed (Pn600=0). The control mode (second mode) and internal set speed can be switched by the /SPD-A and /SPD-B signals. 104 SD700 Series Servo Technical Manual Function Parameter Range Default Unit Communication When code address enabled Pn000 Control mode selection 0~11 0 - 0x0000 After restart 4 - Internal speed Analog speed: Switch control mode via ON/OFF of switch /SPD-A and /SPD-B. 5 - Internal speed Position mode: Switch control mode via ON/OFF of switch /SPD-A and /SPD-B. 6 - Internal speed Torque mode: Switch control mode via ON/OFF of switch /SPD-A and /SPD-B.
7 - Position Mode Analog speed: Switch the control mode through ON/OFF of the switch control mode switch (/C-SEL) signal. 8 - Position mode Torque mode: Switch the control mode through ON/OFF of the switch control mode switch (/C-SEL) signal. 9 - Torque Mode Analog Speed: ON/OFF Switching Control Mode of (C- SEL) Signal Switching Mode. 10 - Analog speed Zero function of speed mode: When control speed, zero fixed function can be used. 11 - Position Mode Position mode of command pulse disabled: When Control position, command pulse disable function can be used. 16 - EtherCAT mode.
Digital input signal Speed command positive and negative Pn000 setting /SPD-D (CN1-41) /SPD-A (CN1-45) /SPD-B (CN1-46) 4 5 6 OFF OFF OFF Second mode determines Analog speed mode Position mode Torque mode OFF ON Positive Internal speed 1 (Pn304)