5.8.3 Control Block Diagram of Full Closed Loop Control 5.8.4 Setting of Motor Rotation Direction And Machine Moving Direction When setting motor rotation direction and machine moving direction for full closed-loop control, pn002 (rotation direction selection) and PN250 (use method of external encoder in full closed-loop control) must be set at the same time. • The frequency division pulse is independent of the setting of pn002, and becomes B-phase lead for forward rotation command. • FWD direction: the direction in which the pulse count is positive. • REV direction: pulse counting is the direction of counting down.
112 SD700 Series Servo Technical Manual Pn257 Setting of excessive deviation between motor and load ○ ─ ─ 3.6 Parameter Pn250 Application of external encoder in full closed loop control 1 3 Pn002 (Motor rotation direction) 0 Command direction FWD command Reverse command FWD command Reverse command Motor rotation direction CCW CW CCW CW External encoder FWD move REV move REV move FWD move 1 Command direction FWD command Reverse command FWD command Reverse command Motor rotation direction CW CCW CW CCW External encoder REV move FWD move FWD move REV move