(Note)1. When the mantissa appears, please round the number after the decimal point. 2. When the pitch value of the external encoder grating ruler with motor rotation for 1 turn is not an integer, relative to the position loop gain (KP), feedforward, position command speed, monitoring as the state of containing error. But it has nothing to do with the position loop, so it will not affect the position accuracy. 5.8.6 Setting of Frequency Divi Set the frequency division output of external position to pn070. The set value should input A, B phase edge values. Pitch of grating ruler of external encoder: 16mm. Pitch of grating ruler of external encoder: 16mm.
Pitch of grating ruler of external encoder: 16mm. Ball screw lead: 16mm. Ball screw lead: 16mm. Ball screw lead: 16mm. Speed: 160mm/s. Speed: 160mm/s. Speed: 160mm/s. The setting value is “4000” when the output is 1 μm with 1 pulse (4 times of increasing value). The setting value is “4000” when The setting value is “8000” w The setting value is “8000” when the output is 0.5 μm with 1 pulse (4 times of increasing value). When the setting is “20” When the setting is “20”, the output waveform of encoder frequency division pulse is shown in the “above figure”. “above figure”. “above figure”.
The upper frequency limit value of encoder signal output is 4Mpps ( 4 times of increasing value 4 times of increasing value4 tim ), so 114 SD700 Series Servo Technical Manual Related parameter Function Parameter Range Default Unit Communication When code address enabled Pn253 Resolution of external grating ruler 4~ 1048576 32768 Pulse/r 0x0253 After Restart Set the pitch value (feedback pulse number) of external grating ruler when the motor shaft rotates for 1 turn Parameter Range Unit EncoderEncoder 5.8.6 Setting of Frequency Division Pulse Output Signal of Grating Ruler / Encoder