6.3 Inertia Identification 6.3.1 Summary “Inertia identification” means that the servo unit performs automatic operation (forward and reverse reciprocating motion) without issuing commands from the host device, and the load rotary inertia is recognized during operation. The rotary inertia ratio (ratio of load rotary inertia to motor rotor inertia) is the reference parameter for performing the gain adjustment, and the correct value must be set. The load rotary inertia can be calculated based on the weight and composition of each part of the mechanism, but the operation is very complex.
With this function, after the motor is driven several times in the positive/negative direction, a high-precision load rotary inertia can be obtained. The motor operates according to the following operating specifications. Maximum speed: ± 1000min-1 (changeable) Acceleration: ± 20000min-1/s (changeable) Travel distance: Maximum ± 2.5 turns (changeable) 6.3.2 Steps The inertia recognition function can only be identified by the PC debugging software “VCSDsoft”. Inertia identification steps refer to “Host device debugging related”- “Inertia identification”.
6.3.3 Additional Notes When identifying the inertia, please make sure that the system can operate the range and set the operating conditions reasonably according to the operable range. Under different operating conditions, the recognition result may have minor deviations. If the servo torque limit is set too small, the result of inertia identification may be affected, resulting in discrepancy between the identification result and the actual inertia. Please confirm before identification. After inertia identification, after changing the inertia ratio (Pn100), the original gain- related parameters of the servo system need to be re-adjusted, otherwise vibration and noise may occur.
Write operation is required after inertia identification, otherwise the inertia identification result is invalid. 124 SD700 Series Servo Technical Manual