6.4 Intelligent Setting 6.4.1 Summary Users can choose intelligent setting with command input and no command input: It means the function of automatically adjusting the servo unit according to the mechanical characteristics when the automatic operation (forward and reverse reciprocating motions) is performed within the set range. Intelligent settings can be performed without connection to the control system. 1) No command input (When there is no pulse from the controller) The automatic operation is as follows: Highest speed: motor rated speed Acceleration torque: motor rated torque about 100% Move distance: can be set arbitrarily.
The factory setting is equivalent to 3 turns of the motor It is the method of automatically adjusting the running command from the host control system. 2) Command input (When a controller sends pulses) The command intelligent setting can also be used for additional adjustments after the no-command intelligent setting. When the correct inertia ratio is set, no-command intelligent setting can be omitted, and only the intelligent setting operation with Commands is performed. ! The command smart setting starts with the present speed loop gain (Pn101) as a reference. If vibration occurs at the start of the adjustment, correct adjustment cannot be performed.
In this case, pls decrease the speed loop gain (Pn101) until the vibration disappears, and then readjust. Cautions The intelligent setting process adjusts the following items: Rotary inertia ratio (No command intelligent setting) Gain adjustment (speed loop gain, position loop gain, etc.) Filter adjustment (torque command filter, notch filter) Friction compensation IF suppression control (intermediate frequency) Vibration suppression Low-frequency vibration suppression (only when Mode = 2 or 3) (No command intelligent setting) 125 SD700 Series Servo Technical Manual