6.4.2 Steps The intelligent setting function cannot be set by the panel keyboard, and it needs to cooperate with the PC debugging software to perform related operations. No command intelligent setting is slightly different from the related operation of the command intelligent setting. For detailed steps, see “host computer operation instructions” - “Intelligent setting”. 1) Confirmation before execution Before perform intelligent settings, be sure to confirm the following settings. If set incorrectly, this function cannot be performed during operation.
No overtravel has occurred Not torque control Gain switching selection switch is manual gain switching (Pn110 = 0) and is the first gain No motor test function is invalid (Pn730 = 0) No alarm or warning occurred Robust control function is invalid (Pn175 = 0) 1. When executing intelligent setting without command in speed control state, it will automatically switch to position control to execute adjustment, and return to speed control after adjustment. 2. The intelligent setting with command cannot be executed in the torque control state. 3. In the process of intelligent setting, the command pulse input multiplier switching function will become invalid.
Cautions ! 2) Failed to perform adjustment or adjustment failed example In the following occasions, intelligent settings will not be performed properly. Please use the bandwidth setting (see “Bandwidth setting” for details):
The motor is power ON (servo ON) in position control (with command intelligent setting) When the mechanical system can only run in one direction The scope of activities is narrow, below 0.5 round When the rotary inertia changes within the set operating range When the mechanical dynamic friction is large The mechanical rigidity is low and vibration occurs during positioning When P (proportional) control is selected, “Load inertia moment measurement” is selected, In the process of rotary inertial identification, or when switching to P control through P/CON signal When using the mode switch, when “Load moment of inertia measurement” is selected, the mode switch function becomes invalid during the moment of inertia identification and becomes PI control.
The mode switch function becomes valid again after the rotary 126 SD700 Series Servo Technical Manual