6.5 Bandwidth Setting 6.5.1 Profile The bandwidth setting is a method of inputting a speed command or a position command from the host device, and manually adjusting the running speed. By adjusting one or two values with the bandwidth setting, the relevant servo gain setting can be automatically adjusted. The bandwidth setting adjusts the following items:
Gain adjustment (speed loop gain, position loop gain, etc.) Filter adjustment (torque command filter, notch filter) Friction compensation IF (intermediate frequency) suppression control Low frequency vibration suppression Use the bandwidth setting when you cannot achieve satisfactory response characteristics after setting it by intelligent settings. If you want to further fine-tune each servo gain after adjusting the bandwidth setting, see “Manual Adjustment Function” for manual tuning 6.5.2 Steps Before performing bandwidth setting, be sure to confirm the following settings.
If it is set incorrectly, “NO-OP” will be displayed in the operation and this function cannot be performed. Invalid selection of no motor test function (Pn730 = 0) 129 SD700 Series Servo Technical Manual Pn153 Notch filter 1 frequency Pn154 Notch filter 1 Q value Pn155 Notch filter 1 depth Pn156 Notch filter 2 frequency Pn157 Notch Filter 2 Q Value Pn158 Notch filter 2 depth Pn240 Model tracking control selection Pn241 Model tracking control gain Pn242 Model tracking control attenuation coefficient Pn243 Model tracking control speed feed forward gain Pn244 Model tracking control forward torque feed forward gain Pn245 Model tracking control reverse torque feed forward gain