VEICHI — SD700 User Manual 20230516

(2) Feed forward function In the factory setting mode, when excute tuning mode by “2” & “3”, “feedforward command (Pn109)”, “speed feedforward (VREF) input”, and “torque feedforward (T-REF) input” will be invalid. According to the system configuration, if you want to use “V-REF input”, “Torque feed forward (T- REF) input”, and model tracking control from the host device at the same time, set Pn249 = 1. ! When using model tracking control with this function, the model tracking control sets the optimal feedforward inside the servo. Therefore, the "velocity feedforward (V- REF) input" and "torque feedforward (T- REF) input" from the upper unit are usually not used simultaneously.

If the input feedforward is incorrect, it may cause overshoot, but please note that it can be used as necessary. Cautions 6.5.4 Related Parameters The relevant parameters and parameters that are automatically set when executing the bandwidth setting function are as follows: 131 SD700 Series Servo Technical Manual 0- Automatic adjustment without auxiliary functions. 1- Automatic adjustment through auxiliary functions.

Pn231 Low frequency vibration suppression function automatic adjustment selection 0x00~ 0x01 1 - 0x0231 Immediately This parameter is set in the intelligent settings, bandwidth settings and other auxiliary functions under low-frequency vibration suppression is automatically set to choose: 0 - Vibration suppression function is not automatically adjusted by auxiliary functions. 1 - Vibration suppression function is automatically adjusted by auxiliary functions.

Parameter Name Pn100 Rotary inertia ratio Pn101 First speed gain Pn102 First speed integral time constant Pn103 First position gain Pn104 First torque command filter Pn140 IF vibration suppression control selection Pn141 IF vibration suppression inertia modification Pn142 IF suppression frequency Pn143 IF suppression attenuation gain Pn153 Notch filter 1 frequency