VEICHI — SD700 User Manual 20230516

6.6 Manual Adjustment Function This function is needed for further individual adjustment requirement after the adjustment of intelligent setting and bandwidth setting. 6.6.1 Servo Gain Position control loop Speed control loop + Command Deviation Position loop + controller Speed Tf + - Current converter Power Servo motor M input counter - gain Kp - KV Ti controller Position loop Speed loop Current loop PG Encoder Please adjust each servo gain one by one after fully understanding the composition and characteristics of the servo units if the servo gain needs to be adjusted manually. In most cases, if one parameter changes significantly, the other parameters must be adjusted again.

In order to confirm the response characteristics, preparations must be made to observe the output waveform of the analog monitor using a measuring instrument. The servo unit consists of three feedback loops (position loop, speed loop, and current loop). The outermost is the position loop and the innermost is the current loop. The more the inner loop, the more it needs to improve the responsiveness. Failure to follow this principle will result in poor responsiveness or vibration. Since the current loop ensures sufficient responsiveness, the user does not have to make adjustments.

132 SD700 Series Servo Technical Manual Pn154 Notch filter 1 Q value Pn155 Notch filter 1 depth Pn156 Notch filter 2 frequency Pn157 Notch Filter 2 Q Value Pn158 Notch filter 2 depth Pn240 Model tracking control selection Pn241 Model tracking control gain Pn242 Model tracking control attenuation coefficient Pn243 Model tracking control speed feed forward gain Pn244 Model tracking control forward torque feed forward gain Pn245 Model tracking control reverse torque feed forward gain