Switching gain combination 1. The gain switching of model tracking control gain and model tracking control attenuation coefficient is only applicable to "manual gain switching". 2. The gain switching of model tracking control gain and model tracking control attenuation coefficient can only be switched when the following conditions are met. -No command. -Motor is stopped. ! Cautions (1) Manually switch “Manual switching gain” means the first gain and the second gain are switched by the external input signal “gain switching signal (/G-SEL)”. a) Gain switching configuration The signal is not configured in the factory default digital configuration.
Therefore, the pin number configuration (0x0E) needs to be configurated by parameters Pn601 ~ Pn609. b) Gain switching wiring The gain switching signal is a general configurable digital input. See “Sequence Input Circuit” for wiring details. (2) Automatic switching 135 SD700 Series Servo Technical Manual The waiting time from when the switching condition of the first gain to the second gain is met to the time when the switching actually starts. Pn115 Gain switching wait time 2 0~65535 0 ms 0x0115 Immediately The waiting time from when the switching condition of the second gain to the first gain is met to the time when the switching actually starts.
Speed loop Torque Model Model tracking Switching Speed Position integration command tracking control gain gain loop gain loop gain time constant filter control correction First gain First speed loop gain (Pn101) First speed loop integration time constant (Pn102) First position loop gain (Pn103) First torque command filter (Pn104) i First model tracking control gain (Pn241) First model tracking control gain attenuation coefficient (Pn242) Second gain Second speed loop gain (Pn105) Second speed loop integration time constant (Pn106) Second position loop gain (Pn107) Second torque command filter (Pn108) Second model tracking control gain (Pn246) Second model tracking control gain attenuation coefficient (Pn247)