6.6.3 Speed Feedforward Feedforward is the function of feedforward compensation to shorten the positioning time during position control. The speed feedforward is divided into internal speed fee forward (Pn121/Pn122) and analog (V-REF) given speed feedforward (using V-REF as speed feedforward selection Pn123). This command is sent to the servo unit together with the position command. Related parameters 6.6.4 Torque Feedforward Torque feedforward is a function to shorten the positioning time. The command is generated by deviating the position command on the host device side. This command is sent to the servo together with the speed command.
The speed command from the host device is connected to V-REF (CN1-5, 6), and the torque 137 SD700 Series Servo Technical Manual Function Parameter Range Default Unit Communication When code address enabled Pn121 Speed feedforward gain 0~100 0 % 0x0121 Immediately Speed feedforward is a function to shorten the positioning time. This function is effective when the servo unit performs position control. Note: When the feedforward command is too large, position overshooting will occur. Please check the response and set appropriately.
Pn122 Speed feedforward filter time 0~64 0.00 ms 0x0122 Immediately Speed feedforward low-pass filter time constant, which can slow position overshoot and torque jump caused by feedforward. Pn123 Use V-REF as speed feedforward selection 0x00 ~ 0x01 0 - 0x0123 After restart Speed feedforward is a function to shorten the positioning time. It is possible to select speed feedforward given via external analog V-REF. 0-None. 1-Use V-REF as speed feedforward input. Pn300 Analog speed command gain 150 ~ 3000 600 0.01V/ rated speed 0x0300 Immediately Use this parameter to set the analog voltage value of (V-REF) required by speed command that makes the servo motor speed as rated value. Note:
Do not apply a voltage over-10V~10V. Exceeding this range may damage the servo drive.