DATA/SHIFT Long press Auxiliary function MODE/SET UP DATA/SHIFT Long press MODE/SET Any interface Auxiliary function adjustment Automatic offset adjustment automatic Enter confirmation Adjustment Flash2s 7.9 Speed command Offset Manual Adjustment (Fn101) 7.9.1 Overview The method of directly inputting the command offset for adjustment. Manual adjustments are used for the following occasions: The host device has built a position loop and when the position deviation of the servo lock stop is set to zero. When you need to set an offset. When confirming the offset set by automatic adjustment.
7.9.2 Operating Procedure Auxiliary DATA/SHIFT Long press Adjust the interface UP function median position Any interface MODE/SET Auxiliary function Manual offset adjustment DATA/SHIFT Long press Enter manual offset DATA/SHIFT Short press interface low Adjust the DATA/SHIFT Long press adjustment position UP/DOWN confirmation Adjustment MODE/SET Adjust the interface 7.10 Torque Command Offset Manual Adjustment (Fn102) 7.10.1 Overview It is a method of directly input the torque command offset. Manual adjustments are used for the following occasions: When you need to set an offset. When confirming the offset set by automatic adjustment. 147 SD700 Series Servo Technical Manual