VEICHI — SD700 User Manual 20230516

If this function is performed incorrectly during manual adjustment, the characteristics may be degraded. When performing manual adjustment, observe the following precautions. -Make the servo motor speed approximately 100 min -1 . -Observe the torque command in the analog monitoring state and adjust the pulsation to the minimum. The offset of the U current and V current of the servo motor must be adjusted in a balanced manner. Please repeat the adjustment several times alternately.

! Cautions 7.12.2 Operating Procedure Long press DATA/SHIFT Long press DATA/SHIFT Long press DATA/SHIFT Any interface MODE/SET Auxiliary function UP Manually zero current U - adjustment phase offset manual MODE/SET V - adjustment phase offset manual Short press Short press adjustment U phase DATA/SHIFT adjustment V p hase DATA/SHIFT 7.13 Initializing the Detection Value of Vibration Detection (Fn105) 7.13.1 Overview The vibration detection function can detect the vibration in the feedback speed of the servo motor. This function is used to detect the “vibration warning (Er. 520)” and “vibration alarm (AL.

911)” that is more accurately after detecting the machine vibration in the running state, and the function also could be used to automatically set the vibration detection value (Pn187). Related parameters as below: 149 SD700 Series Servo Technical Manual Function Parameter Range Defaults Co Unit mmunication When enabled code address Pn185 Vibration detection options 0x00~0x02 0 - 0x0185 Immediately This function is to automatically detect related alarms or warnings after detecting machine vibration under normal operating conditions. Set the servo action after vibration is detected: 0-No vibration detection. 1-Warning after vibration is detected. 2-Alarming after vibration is detected.

Pn186 Vibration detection 50~500 100 % 0x0186 Immediately