! When the servo gain is set incorrectly, it may be difficult to detect the vibration. And it may not be possible to detect all the vibrations that have occurred. When you set the improper moment of inertia ratio (Pn100), vibration warnings and vibration alarms may be detected by mistake or not detected. This operation is performed when the motor is operated with actually used instructions. When performing this action, make sure that the motor runs at a maximum speed of 10% or more.
Cautions 7.13.2 Operating Procedure Auxiliary function DATA/SHIFT Long press DATA/SHIFT Long press MODE/SET UP Vibration DATA/SHIFT Long press MODE/SET Initialization Any interface Auxiliary function initialization detection Initialization preparation Flash2s MODE/SET confirmation Initialization 7.14 Bandwidth Settings (Fn303) 7.14.1 Overview Bandwidth setting is a method of inputting a speed command or position command from the upper unit and manually adjusting it while running. By adjusting one or two values with the bandwidth setting, the setting value of the related servo gain can be adjusted automatically. The bandwidth setting adjusts the following items:
Gain adjustment (speed loop gain, position loop gain, etc.) Filter adjustment (Torque command filter, notch filter) 150 SD700 Series Servo Technical Manual sensitivity Set the sensitivity of the vibration detection. The smaller the setting value is, the more sensitive it is. If the setting is too small, the vibration may be detected by mistake during normal operation. Note: The detection sensitivity of vibration alarm and vibration warning may vary according to different mechanical conditions. Pn187 Vibration detection value 0~5000 50 rpm 0x0187 Immediately Set the threshold for vibration detection. The smaller the setting is, the easier it is to detect the vibration.
If the setting is too small, the vibration may be detected by mistake during normal operation. Note: The vibration detection values of vibration alarm and vibration warning may vary according to different mechanical conditions.