VEICHI — SD700 User Manual 20230516

 Friction compensation  Medium frequency vibration suppression control  Low frequency vibration suppression  Use the bandwidth setting when satisfactory response characteristics are not obtained by intelligent setting. If you want to further fine-tune each servo gain after adjusting the bandwidth setting, see "Manual tuning" for details and perform manual tuning.

7.14.2 Operating Procedure DATA/SHIFT Long press selection Mode UP DATA/SHIFT Long press UP/DOWN DATA/SHIFT Short press Any interface MODE/SET Auxiliary function Bandwidth setting Tuning mode Gain adjustment UP/DOWN confirmation Gain MODE/SET Gain setting Flash2s 7.15 EasyFFT (Fn401) 7.15.1 Overview EasyFFT transfers the periodic waveform commands from the servo unit to the servo motor, and slightly rotates the servo motor several times over a certain period, causing the machine vibration. The servo unit detects the resonance frequency basing on the vibration generated by the machine, and then sets the corresponding notch filter according to the resonance frequency.

The notch filter effectively eliminates high-frequency vibrations and noise. If vibration occurs with a loud sound (abnormal sound) during operation, perform this function after the servo is turned off. ! 1. It must be used in the low gain state such as the initial stage of servo adjustment. If you perform the EasyFFT function after setting a high gain, the machine may vibrate due to mechanical characteristics and gain balance. 2. The detected resonance frequency can be automatically set to the notch filter 1/2. If 1 has been set, it will be automatically set to 2. If 1/2 are both set, the notch filter cannot be set by this operation. 3.

When changing the amplitude setting value, gradually increase the amplitude value and change it while observing the situation. Cautions 151 SD700 Series Servo Technical Manual