234 SD700 Series Servo Technical Manual (straight line) (acceleration) Pn140 IF suppression control options 0x00~ 0x11 0x0010 - 0x0140 Immediately The IF suppression control function effectively suppresses the continuous vibration of about 100 to 1000 Hz that occurs when the control gain is increased. 0x1#: Automatic setting of IF suppression frequency through intelligent setting and bandwidth setting. 0x0#: Not set by intelligent setting, bandwidth setting, only manual setting. 0x#1: IF suppression frequency setting is valid. 0x#0: IF suppression frequency setting is invalid.
Pn141 Inertial modification of IF vibration suppression 1~1000 100 % 0x0141 Immediately Pn142 IF suppression frequency 1~3000 100.0 Hz 0x0142 Immediately Set IF vibration frequency value. Pn143 IF vibration suppression attenuation gain 0~300 0 % 0x0143 Immediately Increasing this parameter can increase the vibration suppression effect. However, if the setting is too large, the vibration may be increased. When confirming the vibration suppression effect, simultaneously gradually increase the setting value by each 10% in the range of 0% to 200%. If the vibration suppression effect is still not achieved after reaching 200%, please stop the setting and reduce the control gain appropriately.
Pn150 Notch filter 1 automatic adjustment selection 0x00~ 0x01 1 - 0x0150 Immediately 0 - Automatic adjustment without auxiliary functions. 1 - Automatic adjustment through auxiliary functions. Pn151 Notch filter 2 automatic adjustment selection 0x00~ 0x01 1 - 0x0151 Immediately 0 - Automatic adjustment without auxiliary functions. 1 - Automatic adjustment through auxiliary functions. Pn152 Automatic notch resonance detection sensitivity 1~200 100 % 0x0152 Immediately It’s used to set the sensitivity for automatically detecting the resonant frequency.
The smaller the value is set, the more sensitive it will be for resonance, the easier it is to detect vibration, and the smaller it is, the more likely it is to falsely detect the resonance frequency. Pn153 Notch filter 1 frequency 50~ 5000 5000 Hz 0x0153 Immediately Set the frequency of the first notch filter that suppresses resonance. When this parameter is set to 5000, the function of the notch filter is invalid. Note: Do not set the notch filter frequency close to the response frequency of the speed loop. At least this frequency should be set to more than 4 times of the speed loop gain, otherwise it may affect the overall performance of the system.
Pn154 Notch filter 1Q value 0.5~10 0.70 - 0x0154 Immediately The Q value of the notch filter refers to the setting value of the filter frequency width related to the notch filter frequency. The width of the recess varies with the Q value of the notch filter, and the larger the Q value of the notch filter is set,the more sunk and the narrower the width of the filter frequency will be. Pn155 Notch filter 1 depth 0~1 0.000 - 0x0155 Immediately The notch filter depth refers to the setting of the filter frequency depth related to the notch filter frequency. The depth of the recess varies with the depth of the notch filter.