236 SD700 Series Servo Technical Manual friction compensation cut-off speed at a rate of 10% each within the range that does not generate vibration. Pn171 Friction torque positive compensation coefficient 0~100 0 %/100rpm 0x0171 Immediately The setting value is higher, the effect is better. However, if the setting value is too high, the response is more likely to vibrate. Usually we set the value below 95%. Pn172 Friction torque reverse compensation coefficient 0~100 0 %/100rpm 0x0172 Immediately The setting value is higher, the effect is better. However, if the setting value is too high, the response is more likely to vibrate. Usually we set the value below 95%.
Pn175 Robust control selection 0x00~ 0x01 1 - 0x0175 After restart Robust control function means that the function of stable response can be obtained through automatic adjustment within a certain range, regardless of mechanical type, load fluctuation, or inertia change. 0-Invalid. 1-Valid. Pn177 Robust control tuning value 10~80 40.0 Hz 0x0177 Immediately Set the gain-tuning value of the robust control. The setting value is larger, system responds is faster, but system overshoot and excessive noise may occur. Pn178 Minimum load value of robust control 0~500 0 % 0x0178 Immediately Set the robust control load factor.
The larger the value is set, the faster the system responds, but it will be noisier. When the inertia is large, increasing the value properly could reduce overshoot. Pn185 Vibration detection selection 0x00~ 0x02 0 - 0x0185 Immediately This function refers to the function of automatically selecting alarm or warning after detecting the machine vibration under normal operation. Set the expression after vibration detection: 0 - No vibration detected. 1 - Warning after vibration detected. 2 - Alarm after vibration detected. Pn186 Vibration detection sensitivity 50~500 100 % 0x0186 Immediately Set the sensitivity of the detected vibration. The setting value is smaller, the sensitive is more.
If the setting is too small, the vibration may be detected by mistake during normal operation. Note: The detection sensitivity of the vibration warning and vibration alarm may differ depending on the state of the machine being used. Pn187 Vibration detection value 0~5000 50 rpm 0x0187 Immediately Set the threshold for vibration detection. The setting value is smller, the vibration detected is easier. If the setting is too small, the vibration may be detected by mistake during normal operation. Note: The vibration detection values of vibration warning and vibration alarm may differ according to the condition of the used machine.