VEICHI — SD700 User Manual 20230516

238 SD700 Series Servo Technical Manual When the full closed loop is valid: The electronic gear ratio is the ratio of the workpiece movement of 1 pulse unit input command by the host device to the movement of 1 pulse output by the grating ruler. If the screw is driven, the screw pitch is 10mm and the resolution of the grating ruler is 0.5um. The number of pulses required by the host system for the motor to rotate 1r is 20000, that is, the pulse equivalent is 0.5um/pulse, and the movement of the grating ruler is 0.5um, corresponding to outputting one pulse, then: Pn208 Internal position command 0~4 0 - 0x0208 After restart 0-Position command select external pulse input.

1-Position command select internal position command. 2-Chasing and shearing electronic cam . 3-Reserved. 4-CANopen mode. When using CANopen mode, Pn208 must be set to 4 (CANopen mode). Pn211 Position command low-pass filter time constant 0~655 0 ms 0x0211 Cease to take effect This parameter is used to set the time constant of the first-order low-pass filter corresponding to the position command and it can reduce the mechanical shock in the case of abrupt changes in the input pulse command frequency by setting this parameter.

Pn212 Average filter time in position instruction rolling 0~1000 0 ms 0x0212 Cease to take effect This parameter is used to set the time constant of the moving average filter of the corresponding position instruction. It can reduce the mechanical shock in the case of abrupt changes in the input pulse command frequency by setting this parameter. Pn230 Low-frequency vibration suppression selection 0x00~0x02 0 - 0x0230 Immediately This parameter is used with Pn231 as the automatic adjustment mode setting. 0- No vibration suppression. 1- Additional vibration suppression function for specific frequency. 2- Additional vibration suppression to 2 different frequencies.

Pn231 Automatic adjustment selection in low- frequency vibration suppression 0x00~0x01 1 - 0x0231 Immediately