Type 2 alarms can select zero speed stop in addition to the servo OFF method and type 1 alarm stop method. See the description of parameter Pn053 for the torque limit at zero speed stop. Cautions Cautions ! ! The setting of zero speed stop method is only valid for position control and speed control. The setting of zero speed stop method is only valid for position control and speed control. 5.1.5 Electromagnetic Brake A holding brake is a brake used to hold the position of the movable part of the machine when the Servo unit is turned OFF so that movable part does not move due to gravity or external forces. Holding brakes are built into servomotors with brakes. Please use it as shown below.
Vertical Axis Shaft with External Force Applied Servo motor Moving part of machine Holding brake External force servo motor Prevents the moving part from falling due to gravity when the power supply is OFF. Holding brake Moving part of machine. Prevents the moving part from moving due to an external force. The brake has the following operation delay time. ON and OFF of the operation, please ensure the brake operation time. Servo enable signal (/S-ON) Motor power Brake linkage signal (/BK) Electromagnetic brake status Position, speed command 1. Different types of brakes may have slight difference on the time of holding brakes and loosening brakes.
75 SD700 Series Servo Technical Manual OFF ON OFF ON ON OFF OFF 3 3 OFF Brake holdin ON OFF Brake holding 1 1 No 1 2