2. Please ensure that the input command is after the brake opening operation to ensure the accuracy of the command. 3. When the motor is locked, it may cause danger when the servo motor is prevented from operating when the servo is turned off. The motor lock time (Pn008) can be set to ensure that the motor during the brake is not operated. (1) /BK signal OFF timing during the motor running When an alarm occurs during servo motor rotation, the servo motor stops and the brake signal (/BK) turns OFF.
At this time, the brake signal (/BK) output time can be adjusted by setting the brake command output speed value (Pn010) and the servo OFF - brake command waiting time (Pn009), the brake signal (/BK) output time can be adjusted. Servo enable signal (/S-ON) Brake linkage signal(/BK) Motor power Brake delay release speed Pn010 Feedback speed 2 Brake delay Pn009 1. When the motor speed is lower than the set value of Pn010 after the power to the servo motor is turned OFF, the /BK signal output time is subject to 1. 2. When the time set in Pn009 is exceeded after the power to the servo motor is turned OFF, and the output time of /BK signal is subject to 2.
(2) /BK signal OFF timing during the motor stopped and locked When the servo motor is stopped, the brake (/BK) signal and the servo ON (/S-ON) signal are turned off at the same time. By setting Pn008, it is possible to change the time from when the servo ON (/S- ON) signal is OFF to when the motor actually enters the non-energized state. 76 SD700 Series Servo Technical Manual ON ) ON Motor power 1 OFF Motor is n powered