VEICHI — SD700 User Manual 20230516

Related monitoring data: ! 1. When replacing the battery, please do it when the drive is powered on and the encoder line is connected normally, otherwise the encoder backup warning will be reported when it is connected again, at which time the absolute position is lost and it is necessary to clear the multi-turn encoding circle action again. Cautions 5.1.9 Torque Limit 1.Torque limit method For the purpose of protecting the machine etc., the output torque can be limited and set by parameter Pn050. The torque limit can be set in the following five ways: ! 1. The input voltage of the analog command for torque limiting has no polarity.

The absolute value of the voltage is taken, and the torque limiting value corresponding to that absolute value is used in both the forward direction and the reverse direction. 2. If the set value exceeds the maximum torque of the servo motor used, the actual torque is also limited to th i t f th t Cautions 80 SD700 Series Servo Technical Manual clear the encoder multi-turn value at the same time, and the single-turn value will be retained. Monitoring code Monitoring name Range Unit Communication address Un010 Absolute encoder 0x80000000~ Encoder 0xE011 single-turn value 0x7fffffff pulse unit Displays the single-turn absolute position of the absolute encoder.

Un011 Absolute encoder multi-turn value 0x80000000~ 0x7fffffff Encoder pulse unit 0xE011 Display the number of turns of the multi-turn encoder when the multi-turn encoder is used. After the multi-turn encoder reset operation is performed, the value is 0. Pn050 Torque limit method description Related parameters 0 Analog torque (torque mode is invalid) Pn405 1 Maximum torque limit 1 Pn051 2 Positive torque limit 1 (Pn051), reverse maximum torque limit 2 Pn051 Pn052 3 Maximum torque limit 1 when the torque limit switching (/TLC) signal is OFF; Maximum torque limit 2 when ON. Pn051 Pn052 4 Restricted by internal torque command (effective in torque mode) Pn410