5.2.2 Basic Settings The following describes the basic settings for position control: 1. Command pulse filter selection The appropriate command pulse filter can be selected according to the frequency of the highest pulse in operation, which can be set by parameter Pn200. For details, refer to the relevant description of the function code. If the selection is not appropriate, the received pulse of the servo unit may be lost or increased. According to the pulse output form of the upper system, the pulse input form of the servo unit is selected. 2. Pulse input form 3.
Electronic gear ratio When the reduction ratio of the motor shaft and the load side is n/m (when the load shaft rotates by n revolutions when the motor rotates by m revolutions), the set value of the electronic gear ratio 83 SD700 Series Servo Technical Manual Function Setting Order form Forward instruction Reverse instruction code value Pn201 0 Pulse + direction positive logic 1 CW+CCW positive logic 4 Quadrature encoding 4 times 5 Pulse + direction negative logic 6 CW+CCW negative logic