VEICHI — SD700 User Manual 20230516

5.2.6 Positioning Completion In position control, it indicates the servo motor positioning completed (/COIN) signal. 1. Positioning completed configuration In the factory default digital output configuration, the signal is configured as CN1's 27th and 28th pin numbers (Pn614=0x01) by default. Please confirm before use. If the set value is too large, the permanent positioning completion signal may be output when the deviation is small during low-speed operation. When outputting a constant positioning signal, please lower the setting until the signal is no longer output.

87 SD700 Series Servo Technical Manual Function Parameter Range Default Unit Communication When enabled code address Pn262 Positioning completion range 0~ 1073741824 7 Command unit 0x0262 0x0263 Immediately In the position control, the servo motor positioning completion signal will be output when the difference between the command pulse number from the host device and the servo motor movement amount (position deviation) is lower than the set value that means the host device confirming positioning has been completed.

Function Parameter Range Default Unit Communication address When code enabled Pn274 Positioning completion signal output time 0x00~ 0x02 0 - 0x0274 Immediately Set the output timing of the positioning completion signal /COIN: 0- Output when the absolute value of position deviation is less than the positioning completion range (Pn262). 1- Output when the absolute value of the position deviation is smaller than the positioning completion range (Pn262) and the command after the position command filtering is 0. 2- Output When the absolute value of the position deviation is smaller than the positioning completion range (Pn262) and the positioning command input is 0.