Assembly ................. '" ........ i,,i = ..... PH.....,.H ..,=...... = Installing Handwheels and Bevel Pointer 1 From the bag labeled "Miscellaneous" remove only the following hardware: 10-32 x 5/8 In. Pan Head Screw Type "T" 8-32 x 3/8 In. Pan Head Screw *2 Pan Head Screws, 10 - 32 x 5/8" Long *2 Lockwashers, #10 External Type "1 Par} Head Screw Type "T" 8-32 x 3/8 Long 1 Bevel Pointer O Handwheel Bevel Pointer #10 External Lockwasher From the bag labeled "Large Parts" remove only the following: 2 Handwheels Items marked with asterisk (*) are shown actual size 2, Fasten bevel pointer to cradle assembly with 8-32 x 3/8 screw, as shown.
Adjustment of the pointer may be nec- essary later Lockwasher 3 Line up flat spots on shaft and handwheel, push handwheel onto shaft.. Install screw and !ockwasher to lock handwheel on shaft. Repeat for the other hand- wheel Screw Tilt Handwheel Bevel Pointer / Pan Head Elevation Handwheel Screw 0© Assembling Steel Legs t From the bag labeled "Legs" remove the following hardware: 1/4-20 x 112In russ Head Screw Q 1/4 In. External 1/4-20 Lockwasher Hex Nut "16 Truss Head Screws, 1/4-20 x 1/Z' long "16 Lockwashers, 1/4" External Type "I6 Hex Nuts, 1/4-20 *8 Hex Nuts, 3/8-16 4 Leveling Feet From among the loose parts find the following:
4 Legs 2 End Stiffeners 3/8 -16 Hex Nut Leveling Foot 2 Side Stiffeners Leg items marked w{th asterisk (*) are shown actual size 2 Assemble the legs as shown insert the truss head screws through the holes in the legs, then through the holes in the side and end stiffen- ers Stiffener Legs must be assembled on top of stiffeners Side Stiffeners'_ .,,j End Stiffeners 3 Install the Iockwashers Screw on the nuts hand tight. 4 Instal! leveling feet through hotes in bottom of legs as shown. 5 Adjust teveling feet as follows: a Move saw to desired location.. b. With 9/16" wrench loosen bottom nut c Back off top nut by"hand d Raise or lower foot by adjusting bottom nut using 9/16" wrench..
e..Snug top nut against inside of leg by hand.. 1/4-20 Hex Nut Truss Head Screw f Tighten all four bottom nuts using 9/16" wrench Lockwasher Hex Nuts Leveling Foot ----_ 12