Mounting Your Saw 1 From the bag labeled "Base" remove the following hardware: *4 Hex Head Screws, 5/16-18 x 1-I/8" Long 5t16-18 x 1-1/8 In 5/16-18 Hex Head Screw Hex Nut *4 Hex Nuts, 5/16-18 *4 Lockwashers, 5/16" External Type *8 Fiat Washers, tl/32 x 11/16 x 1/16 2 Place the saw upside down onto a smooth piece of cardboard or heavy paper, on the floor, so the saw is resting on the table top items marked with asterisk (*) are shown actual size 5/16 In External Lockwasher 11/32 LD. Flat Washer WARNING: The saw is heavy. To avoid back injury, get help to lift the saw. Hold the saw close to your body. Bend your knees so you can lift with your 3.
Place legs on saw so that holes in saw base and leg set line up and trim label is facing front. Legs will over- hang base in rear 4. Install screw, washers, lockwasher and nut as shown Cardb, 5 Tighten all leg assembly and mounting hardware at this time Hex Leg Set Flat Washer End Stiffener Flat Washer Hex Head Screw Saw Base NOTE:
For clarity, later manual illustrations may not show leg set attached Bench Mounting If you do net use the legset and prefer to mount the saw on a bench, make sure that there is an opening in the top of the bench the same size as the opening in the bottom of the saw so that the sawdust can drop through Recom- mended working height is 33 to 37 inches from the top of the saw table to the floor 14-3/4 12 1/2--,-- _l Front of Saw NOTE: All dimensions in inches 13