Assembly (continued) 3 Mount switch to front guide bar with two 5/16-!8 x 3/4 hex head screws, tour lockwashers and two nuts_ Securely tighten both nuts Hex Nuts ,, 1 Lockwashers _'_ _ Loekwashers 3/4 In. Hex Head Screws 4 Place front guide bar against saw table and drop it in place engaging the screws in the slots, Make sure the spacers are between the front guide bar and the table Lockwasher Hex Nut 5 End of front guide bar must be 7-5/16 inch from side of saw table, This is important so that rip fence indi- cator can be aligned 1-1/2 In.
Hex Head Screw @ 7-5!16 |no 6 With the blade of your combination square set to 1/4 inch, gauge and adjust front guide bar so the edge of the bar is 1/4 inch above the edge of the table, Securely tighten nuts, 7 Install 5/16-18 x 1-1/2 hex head screw through the fourth slot in front guide bar (that lines up with bracket), through the 1/4 inch spacer and the bracket, Install a 5/16 inch external lockwasher and 5/16-t8 hex jam nut, 8.
Remove the two truss head screws from rear of right table extension, Hex Nut 9 Attach the rear guide bar in a similar manner to the front guide bar Make sure that the end of the bar is 11 inches from the side of the saw table, Spacers are not required 10 Reinstall two truss head screws, tockwashers and hex nuts removed in step 8. Check that all hardware is tight 11 insert 5/16-18 x 1 hex head screw through the eighth slot in rear guide bar and bracket, Install 5/16 exter- nal Iockwasher and 5/16 hex jam nut Tighten securely Lockwas her' t In, Hex Head Screw Truss Head Screws 1 In. Hex Head Screws 16