Using the Rip Fence o A featherboard can help guide the workpiece_ (See "Basic Saw OperatiomUsing Featherboards for Thru- Sawing" section,) Ripping, bevel ripping, resawing and rabbeting are per- formed using the rip fence together with the auxiliary fence/work support, push stick or push block, ,Always use featherboards for any non thru-sawing rip type cuts, (See "Basic Saw Operations-Using Feather- boards for Non Thru-sawing" section) Before Starting: I WARNING: For your own safety, read and always observe all safety precautions listed in manual and on saw.
Additional Safety instructions for Rip Cuts oTo avoid kickbacks and slips into the blade, make sure the rip fence is parallel to the sawblade Never use the miter gauge when ripping Before thru-sawing, check the anti-kickback pawls, the pawls must stop a kickback once it has started,, Replace or sharpen anti-kickback pawts when points become dull Use a push stick whenever lhe fence is 2 or more inches from the blade, When thru-sawing, use an auxiliary fence and push block whenever the fence must be between 1/2 and 2 inches from the blade ° Plastic and composition (like hardboard) materials may be cut on your saw, However, since these are usually quite hard and slippery, the anti-kickback pawls may not stop a kickback, Therefore, be especially careful in your setup and cutting procedures, Never thru-saw rip cuts narrower than t/2 inch, oNever rip anything shorter than 10" long,.
When using a push stick or push block, the trailing end of the workpiece must be square A push stick or block against an uneven end could slip off or push the work- piece away from the fence, While Thru-sawing: oTo avoid kickbacks and slips into the blade, always push forward on the section of the workpiece between the sawblade and the rip fence Never push forward on the piece being cut off Ripping Always Support Long Or Wide Workpieces Definition: Cutting operation along the length of the work- piece, Position the fence to the desired width of rip and lock in place, Before starting to rip, be sure:
1 Rip fence is parallel to sawblade 3 Anti-kickback pawls are functioning properly, 2 Spreader is properly aligned with sawblade When ripping long boards or large panels, always use a work support A simple support can be made by clamping a piece of plywood to a sawhorse WARNING: To avoid kickback, push forward only ] on the part of the workpiece that will pass between 1 the blade and the fence. Keep your hands out of the blade path, Feed the workpiece by pushing forward only on the part of the workpiece that will pass between the blade and the fence Stop your left thumb at the front edge of the table Finish the cut with the appropriate pusher 31