Basic Saw Operations (continued)- Ripping (continued) Once the trailing end is on the table: Push Stick When "width of rip" is 2" or wider, use the push stick to finish pushing the work all the way past the blade Auxiliary fence When "width of rip" is narrower than 2" the push stick Guard cannot be used because the guard will interfere_ use the \ auxiliary fence and push block., \ Attach auxiliary fence to rip fence with two "C" clamps Feed the workpiece by hand along the auxiliary fence until the end is approximately 1" past the front edge of the table, Continue to feed using the push block.
Push Block Hold the workpiece in position and install the push block by sliding it on top of the auxiliary fence (this may raise guard) Workpiece 32