Seres — SEARS - owner's manual - Home Depot Repair Parts

WARNING:To avoid injury from blade contact neverthru-sawcuts narrowerthan1/2"wide. Baffle Narrow strips thicker than the auxiliary fence/work sup- port may enter the guard and strike the baffle Carefully raise guard only enough to clear the workpiece Use push block to complete cut.

Bevel Ripping Narrow Work When bevel ripping material 6" or narrower, use fence on the right side of the blade only This will provide more space between the fence and the sawblade for use of a push stick If the fence is mounted to the left, the saw- blade guard may interfere with proper use of a push stick H=,, Featherboard Using Featherboards for Thru-Sawing Work Support Featherboards are not employed for thru-sawing opera- tions when using the miter gauge Facing Board Featherboards are used to keep the work in contact with the fence and table as shown, and to help stop kick- backs.

Add a 7-1/2" high flat facing board to the fence, the full length of the fence Mount featherboards to facing board and table as shown, so that leading edges of featherboards will support work- piece edge presses only on the uncut portion (in front of the blade). It might otherwise pinch the blade in the kerf and cause a kickback. l Workpiece I WARNING: Make sure the featherboard against the Featherhoar! Before starting the operation (switch "OFF" and blade below table surface): 1 Install teatherboards so they exert pressure on the workpiece; be positive they are securely attached Push Stick 2. Make sure by trial that the featherboards will stop a kickback if one should occur 33