Maintaining Your Table Saw (continued) Lubrication The saw motor bearings have been packed at the factory with proper lubricant and require no addit}onal lubrication, The following parts should be oiled occasionally with SAE no 20 or no 30 engine oil Stop Elevation Screw (2) 1 Tilt screw threads and pivot nut (First clean with Craftsman Gum and Pitch remover) 2 Elevation screw threads and pivot nut (First clean with Craftsman Gum and Pitch remover ) 3. Cradle bearing points, Spacer t / Screw Pivot Nut t (21 \ J 4, Bearing points in guard assembly, miter gauge and rip fence P Tilt Screw (1) Tilt Screw Pivot Nut (+) 3 4 + 1 4 44