Sears Recommends the Following Accessories Sears Recommends the Following Accessories Item Cat. No. Caster Sets .............................................. See Catalog *7 In, Molding Head Set ......................... See Catalog *7 In., Molding head ............................... See Catalog Molding/Dado Insert for 7 fn Dia,, Molding or Dado Head ............................................... 9-29933 Item Cat. No. Miter Gauge Stop Rods ............................... 9-29924 Miter Gauge Hold-Down Clamp ............................ 9-29928 Storage Hooks (Miter Gauge/Rip Fence) ............ 9-32038 Taper ,Jig.............................................
See Catalog Universal Jig .............................................. See Catalog "Power Tool Know How Handbook" .................. 9-29115 Work Light .................................................... See Catalog Sawdust CoIlection System ............................. 9-29962 Whole Shop Sawdust Collector Kit .............. 9-29964 7 In., Dia. Adjustable Dado Head .................. See Catalog 7 In. Dia Dado Head ............................ See Catalog Sanding Wheel ........................................... See Catalog Miter Gauge .............................................
9-29930 Sears may recommend other accessories not listed in manual See your nearest Sears store for other accessories, Do not use any accessory unless you have received and read complete instructions |or its use * Smaller diameter molding heads cannot be used because they do to provide adequate depth of cut Troubleshooting ............................................................ WARNING: For your own protection, turn switch "OFF" and always remove plug from power source outlet before troubleshooting.
General Trouble Probable Cause Remedy Excessive Vibration 11Blade'"out of balance 1 Discard blade and use a different blade Cannot make square cut when crosscutting 1 Miter gauge not adjusted prop- erly 1 See "Adjustments" section "Miter Gauge" Cut binds, burns or stalls motor when rip- ping. 1 Dull blade or improper tooth set.. 2. Blade is heeling 3 Warped board 1 Sharpen or replace blade 2. See "Adjustments" section, "Heeling Adjustment" 3 Make sure concave or hollow side is facing "down" feed slowly. 4 See "Adjustments" section, "Rip Fence" 5.
See "Assembly" section, "Installing Blade Guard" 4 Rip fence not parallel to blade 5 Spreader out of alignment Cut not true at 90° or 45° positions.. 1 Stop Collars not properly adjusted 1. See "Adjustment" section, "Blade Tilt, or Squareness of Blade to Table" Tilt and elevating hand- wheel turn hard. I Sawdust on threads of tilt screw or elevating screw 2 Bearing retainers too tight. 1 See "Maintaining Your Table Saw" section, Lubrica- tion 2. See "Adjustments" section, "Tilt and Elevation Mechanism" 45